Servicing Tractors
SERVICING YOUR TRACTOR
To keep your tractor running at it's best it is important to regularly service it. Whether it is a modern, classic or vintage tractor, there are key checks to carry out to ensure your tractor runs efficiently.
- Engine oil change
- Engine oil filter change
- Air filter inspection/change
- Lubrication
Materials For Your Oil and Filter Change
Ensure you have all your materials ready to change your oil:
- Container for used oil
- Engine oil
- Oil filter
- Oil filter gasket
An oil change is the most important task you can do to make your engine last. If you have one consult your owner’s manual for the type and weight of oil specific to your tractor. Ensure you invest in the appropriate filter; don’t fill your engine with expensive synthetic oil with an economy filter—it won’t last and will decrease your oil life.
Start by spreading plastic sheeting on the ground. Then drive your tractor on top of it. That will eliminate all oil spill cleanup. If the engine is cold, run it for a while to warm up the oil. If it's already hot, leave for 30 minutes to reduce
temperature. Ensure the engine compartment is clear of debris or this could cause issues later on.
Remove the key from the engine to avoid anyone else starting the tractor (obvious, but it happens). Place a large enough container under the engine sump drain.
Whilst the oil is draining prep the oil filter by date marking it as a reminder of the change. Smear clean oil on the new filter’s gasket (at the base of the filter) this will help seal the filter to the engine block.
Once the new filter is fitted and the oil sump drain plug(s) have been tightened to the specified manufacturers torque setting fill the engine with the recommended oil.
After you have changed the oil start up the engine and let your tractor run for a short time. Now you can check the oil level - adding more if required to the correct level.
Finally you need to dispose of the old oil at your local recycling centre.
Fuel Filter Change
Fuel filters stop debris and contaminants, such as dirt and rust particles from entering your fuel pump, injectors and ultimately your tractors engine, so it is vital to to replace your fuel filter at regular intervals to maintain the highest possible performance and longevity of your tractor.
Air Filter Change
Air filters stop dust and contaminants from entering your tractors engine. They are relatively easy to replace and ensure that clean air reaches your engine, prolonging the life of your tractor and maintaining performance.
Tractor Maintenance Checklist
Use our basic maintenance checklist to help remind you of the key checks you should carry out to keep your tractor running smoothly. Always refer to you manual for your specific make and model recommended service intervals.
CHECK |
FREQUENCY |
---|---|
Oil Level Check | Before Startup |
Fuel Level Check | Before Startup |
Fluid Levels Check | Every 10 hours |
Air Filter Check | Every 10 hours |
Fuel Bowl Check | Every 10 hours |
Wheel Bolts Check | Every 10 hours |
Change Engine Oil and Filter | Every 200 Hours/Annually |
Belts & Hoses Check | Every 200 Hours/Annually |
Hydraulic Lines Check | Every 200 Hours/Annually |
Replace Air Filter | Every 500 Hours |
Replace Fuel Filter | Every 500 Hours |
Change Hydraulic Transmission Oil Filters | Every 500 Hours |
Flush Coolant System | Every 2 Years |
Replace Thermostat | Every 2 Years |